The
SILC industrial garment presses are the result of experience gained over
more than 20 years in the field of steam finishing in more than 40 countries
all over the world.
These
presses have been expressly designed with the precious collaboration of
the best technicians in the finishing sector of some of the most well
known garment manufacturers and offer all the working solutions which
are absolutely necessary nowadays to obtain high quality finishing of
any fabrics.
Among
the main characteristics are:
Functioning. Closing
and controlled descent of top buck without subsequent blocking in the
closed position. Complete closig of bucks, only if required, by the manual
intervention of the operator.
Controls and bucks. Buck
movement control and vacuum control by means of pedal. Blocking and steaming
on top buck by means of levers positioned on the buck itself; steam heated
and steaming top buck. Steam heated and vacuum lower buck; models S/IP4-S/IP1-S/IP6
and S/IP9 also have steaming lower buck.
Pressing
"on distance" - Rapid finishing - Pressure. All the presses are equipped with double pressure regulation. (Visible on pressure gauge). The first gives the possibility
of limiting the distance between the bucks without completely closing
(regulation between 30 mm. and 0 mm.) and of rapid finishing, closing
the bucks but not blocking them in the closed position (between I and
4 ate max.) The second gives the possibility of varying and establishing
constant finishing pressure with blocking of bucks in closed position
(between 0 and 12 ate max.).
Safety devices. Safety
guards are applied on all the bucks, which enable the operator to position
the garment without risk.
Accessories. The presses are designed to be equipped with accessories for self contained
functioning, such as boiler for steam production and vacuum and for the
completion of finishing, such as steam iron set, air-steam gun, spotting
group, fabric safe, and blow on lower buck Elimination of steam and heat
issued from top buck, by means of central vacuum.
Automation. If
automation of the various phases is required, this is possible either
by timers or electronic control box.
|